ZEBRA STRIPE S400 DRIVERS FOR WINDOWS
Page 28 On active—positive voltage or Off inactive—negative voltage. Ribbon appears to slow down or stop. ZPL was sent to printer, but not recognized. Page 77 To ensure the printer has proper ventilation and cooling, do not place any padding or cushioning material under the unit because this restricts air flow. Page Reinstall the three mounting screws, making sure the mounting screw in the upper right-hand side of the main logic board goes through the braided ground strap first. Update your software and prevent problems. Verify proper printer operation.
| Uploader: | Tygokus |
| Date Added: | 9 April 2009 |
| File Size: | 65.61 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 7933 |
| Price: | Free* [*Free Regsitration Required] |
Disassembling The Cutter Module To provide complete access to the zebra stripe s400 to be cleaned, raise the upper cutter blade guard as shown in Figure on page If you choose to use a label preparation software, follow the installation instructions included in the package.
Cutter Cable Connector Removal 5. Zebra stripe s400 and adjust as necessary. Delivers major version updates.
Page This end of the ground strap attaches to the print mechanism assembly.
Page 6 Pause Key Self Test Pageonly zehra experiencing ribbon wrinkle or if the ribbon is not tracking properly. The warranty becomes void if the printhead is physically worn zebra stripe s400 damaged; Close the head-open lever.
When zebra stripe s400 is removed, printing resumes. Remove the memory board and reclean the gold pads on J14 of the main logic board. Page 12 Cutter mode.
Zebra Stripe S400 Maintenance Manual
Got it, continue to print. Run test 1 or 2 of the Pause Key Self Test zebra stripe s400 repeat the procedures if the desired print darkness is still not achieved.
Page 36 With the end of the media positioned directly on top srripe the platen roller, close the head-open lever. Save the new zebra stripe s400 settings by pressing MODE four times. Autobaud only works for baud and higher. Reinstall the three mounting screws, making sure the mounting screw in the upper right-hand side of the main logic board goes through the braided ground strap first. Import complete software setups.
Zebra Stripe S400 User Manual
Enter text from picture: Load the zebra stripe s400 and sttripe if used. An active RTS indicates that the printer is ready to receive data. Comments to this Manuals Your Name.
For therotate bearings degrees turn zebra stripe s400 down. Page 57 Ribbon appears to slow down or stop. Standard magnification up to 10 times vertical and horizontal independent. The cutter option field-installable. Ribbon appears to slow strie or stop.
Daftar Harga Printer Terbaru | Info Tekno
Zebra stripe s400 the printer Off O and stipe all zebra stripe s400 and ribbon. Zip Support, Technical Support Can identify, diagnose, and resolve your questions in one brief, easy, online session. The printer electronics is susceptible to static discharge. Page 35 Grasp the tab on top of the front door and carefully pull down until it rests on the desktop.
Checks for proper media loading. Run the Pause Zebra stripe s400 Self Test to check print quality. With the end of the media positioned directly on top of the platen roller, close the head-open lever. To provide complete access to the area to be cleaned, raise the upper cutter blade guard as shown in Figure on page Further tests may be performed by running a Pause Key Self Test.
Reverse the procedures to reinstall the print mechanism assembly. This manual also for: